Skip to content

Single or dual-run capacitor for an air conditioner?

Select a CBB65 HVAC capacitor by its single or dual µF values, VAC and terminals. Compare 35/5 with 45/5 and identify compressor and fan requirements.

CBB65 single-run capacitor with protective packing and an HVAC subassembly in an industrial workshop.

A single-run capacitor has one capacitance section. A dual-run capacitor combines two sections, commonly serving the compressor and fan in an air conditioner. Match every required µF value and the terminal assignments to the equipment documentation; the can shape does not establish compatibility.

Read a dual value as two separate requirements

A 50+5 µF label identifies separate 50 µF and 5 µF sections. It does not specify a single 55 µF component. In a conventional dual-run HVAC layout, the common terminal is shared by the two sections. C, HERM and FAN markings identify the intended connections on models using those markings; terminal position and the number of blades are not a wiring diagram. AmRad: dual-run terminal markings

The supplied HAN XING photographs show a 20 µF single-run capacitor and a 50+5 µF dual-run capacitor, both marked 450 VAC. Use the equipment documentation to identify the single value or dual pair required for your replacement.

20 µF single-run sample

The label records one nominal capacitance.

50+5 µF dual-run sample

The two capacitance values belong to the two specified circuit sections.

Can 45/5 replace 35/5?

The fan sections are both rated 5 µF, but a 45 µF section does not match a compressor specified for 35 µF. Use the specified pair or an alternative expressly approved for the equipment. Matching the fan section alone is not enough to select a compatible dual-run capacitor.

The same principle applies to 370 VAC, 440 VAC and 450 VAC replacement questions. Preserve both capacitance values and use a voltage rating allowed by the equipment specification. The available HAN XING CBB65 dual-run catalogue range is 1+15 to 15+80 µF at 370–450 VAC; that range does not guarantee every possible pair.

A compressor can need run duty, start duty or both

Air conditioners, heat pumps, condensing units and refrigerated air dryers use different motor circuits. In a refrigerated dryer for a compressed-air system, select the compressor and fan capacitors against their respective motor specifications. The circuit determines whether a CBB65 run capacitor is suitable.

A compressor starting circuit can also use an intermittent-duty start capacitor and switching device. A run capacitor cannot be selected from a start-capacitor value, including a 330 V starting specification. Small refrigerator compressors and electronically controlled systems need the compressor maker’s actual circuit and part reference.

Match the terminal end as well as the can

For a CBB65 cross-reference, retain the OEM part number, electrical values and terminal-end photo together. Round and oval cans can need different brackets. Body dimensions, fastened height and connected terminal clearance determine whether the proposed part will fit. The frequency, tolerance, temperature and safety requirements belong to the same model record.

Source the required CBB65 configuration

Send the equipment reference and the original single value or dual pair, together with the terminal-end photo and bracket dimensions.